Verification: 3408226a20eebf5c

Replacing a burnt headlight bulb | Peugeot 3008 - 5008 |
Low beam, high beam, signal indicator, position lamp

COPYRIGHT WARNING:
All pictures and texts in this web page are the property of nomaallim.com. Any use of any part of those contents without the written consent of nomaallim.com shall be subject to legal procedures as per international and local laws in the concerned country. Using the name "nomaallim" or "nomaallim com" or "nomaallim.com" in the text describing the unauthorized copied content shall not constitute an exception and shall be sanctioned in accordance to the effective laws and proceedings.
  • DIFFICULTY: 1/10
  • NO TOOLS REQUIRED FOR THIS INTERVENTION
  • IF YOU HAVE NO EXPERIENCE, YOU SPEND 15 MINUTES TO CARRY OUT THIS TASK
  • NO SAFETY ISSUES
BEFORE YOU START
  • Take care not to touch a hot engine part.
  • Halogen lamp handling: never touch the glass, this quartz is so fragile that it will be damaged by the natural fat of your hands' skin under high temperatures.
DISCLAIMER:
Our pictorials are of informative nature and do illustrate works carried out by ourselves at our own premises for our own use and satisfaction.
Readers who envisage to carry out similar works inspired by the below method shall do this at their own risks and liability.

Removing the burnt headlight bulb | Shown on a low beam lamp

Look at the back of the headlight and you will immediately see black covers that can be removed by hand.
The picture to the right shows the electric connector inside the headlight.
Pull out the connector.
The picture in the middle now shows the low beam lamp.
Pull it out with your fingers exactly like you did for the connector.
Note well its orientation in order to facilitate the refitting of the new bulb.
In particular, the bulb has one and only "leg" pointing upwards in this case.
High beam, signal light and position lamp are accessed in the same manner by removing the corresponding headlight cover.
All you need to know about the bulb can be found printed on its base. An H7 halogen bulb of 55W in this case which can be easily and widely found in any online shop or a hypermarket.

Refitting a new H7 headlight bulb

All H7 bulbs are identical regardless of the make.
They all have the same dimensions.
Simply push the bulb in its socket making sure of the leg orientation then push the connector after it.
Try pulling out both with lesser force than the one you used to remove them, they should hold well in place.
Refit the cover while pressing on its circumference.
​Try your headlights now!

See also our other pictorials for car bulbs and LED conversion kits further below: