Verification: 3408226a20eebf5c

How to replace the foglight on a Peugeot 3008 or 5008

COPYRIGHT WARNING:
All pictures and texts in this web page are the property of nomaallim.com. Any use of any part of those contents without the written consent of nomaallim.com shall be subject to legal procedures as per international and local laws in the concerned country. Using the name "nomaallim" or "nomaallim com" or "nomaallim.com" in the text describing the unauthorized copied content shall not constitute an exception and shall be sanctioned in accordance to the effective laws and proceedings.
  • OVERALL DIFFICULTY INDEX: 2/10
  • IF YOU HAVE NO TOOLS, YOU SPEND $5 TO GET THEM FOR THIS JOB
  • IF YOU HAVE NO EXPERIENCE YOU SPEND 45 MINUTES TO CARRY OUT THIS JOB
  • SAFETY: NO RISKS 
BEFORE YOU START
  • Replacing the bulb of the foglight requires the same procedure for accessing the foglight and reaching the bulb location.
  • Although shown on a Peugeot 5008, this pictorial remains valid for all Peugeot models
DISCLAIMER:
Our pictorials are of informative nature and do illustrate works carried out by ourselves at our own premises for our own use and satisfaction.
Readers who envisage to carry out similar works inspired by the below method shall do this at their own risks and liability.

Reaching the foglight on a Peugeot 5008

Put your hand on the most angular part of the bumper around the foglight, and pull out gently and perpendicularly to the bumper the plastic part that houses the foglight.

Replacing the entire foglight or its lamp (bulb)

If you're replacing the entire foglight, start by making sure the one you purchased has the same diameter and mounting legs:
The Peugeot 3008 / 5008 foglight is held to the bumper by the means of two Torx screws.
Use any Torx tool in your possession to unscrew them and take out the foglight.
Replace its bulb or disconnect it and remove it completely if you need to replace the entire foglight of the Peugeot vehicle.

Fitting a new foglight on a Peugeot 3008 or 5008

Connect the electrical wires to the new foglight, put it in its place and refit the screws. That's it!
Refit the plastic grille while making sure you aligned all its fixing legs to their seats on the front bumper and push with your hand until it "clicks" and holds well in its intended place.
Make sure of its alignment with the bumper all around.

See also...

...and similar foglight related items you can purchase from our partners' stores: