Verification: 3408226a20eebf5c

How to remove the driver's airbag on a Peugeot 208

COPYRIGHT WARNING:
All pictures and texts in this web page are the property of nomaallim.com. Any use of any part of those contents without the written consent of nomaallim.com shall be subject to legal procedures as per international and local laws in the concerned country. Using the name "nomaallim" or "nomaallim com" or "nomaallim.com" in the text describing the unauthorized copied content shall not constitute an exception and shall be sanctioned in accordance to the effective laws and proceedings.
  • OVERALL DIFFICULTY INDEX: 2/10
  • IF YOU HAVE NO TOOLS YOU SPEND $5 TO GET THEM FOR THIS JOB
  • IF YOU HAVE NO EXPERIENCE YOU SPEND 10 MINUTES TO CARRY OUT THIS JOB
  • RISK OF INJURY OR DEATH FROM A PYROTECHNIC DEVICE, SEE BELOW!
BEFORE YOU START​
​
WARNING: NEVER TEST THE AIRBAG ITSELF OR TRY TO MEASURE ITS RESISTANCE WITH AN OHMMETER. RISK OF TRIGGERING THE PYROTECHNIC DEVICE AND DEPLOYING THE AIRBAG ! 
DISCLAIMER:
Our pictorials are of informative nature and do illustrate works carried out by ourselves at our own premises for our own use and satisfaction.
Readers who envisage to carry out similar works inspired by the below method shall do this at their own risks and liability.

Preparatory works for the removal of a driver's airbag

WARNING: you need first to completely disconnect the battery, both negative and positive terminals, then wait for 15 minutes prior to proceeding with the below. Do not attempt to remove an airbag without disconnecting the battery terminals!
As an additional precautionary measure, push the driver's seat back to the maximum in a manner that you always sit as far as possible from the steering wheel during this intervention.

Removing the driver's airbag on the Peugeot 208

Get two pin removers (pin punch) of any diameter between 3.5 and 5 mm and insert them at the same time in the small holes behind the steering wheel. There are two holes on each side of the steering wheel, one is a perfect circle and the other one is oblong.
​The ones which are circles are the right ones.
Insert the pin removers completely and apply a simultaneous pressure on both by tilting them inwards in a manner to kick the airbag out.
Hold well the airbag as it is still connected with wires.
Disconnect the earth wire first.
Then remove the airbag connector (left, middle) and the horn and beeper connector (right)
Take out the airbag assembly.

See also...

Buy your airbag removal pin or tool here, available at our partners' store: